Faymonville 4-1+3-Achs-Tele-Semi-Multimax mit hydr. Rampen-Twinaxle

Colour : Grey payload weight : 63350 kg. Extendable Braked Available for rental Gooseneck: • Gooseneck in SNT design to optimize the length of the loading area, length approx. 3.700 mm. • Gooseneck at the rear with bevel approx. 1.000 mm x 10°. • Technical fifth wheel load: 30.000 kg. • For Truck: 4x2, 6x2 and 6x4. Loading floor: • Telescopic loading area, length approx. 8.800 mm, with rear bevel approx. 500 mm x 10°. • Deepening in the chamfer as well as intruding in the loading floor to receive the dipper arm of an excavator approx. 3.850 x 750 x 210/290 mm L x W x H). • Pneumatic locking with tapered bolts and reinforced locking positions. • The supply lines are lying protected in the telescopic beam and adjust to respective length of the loading area Ramps: • 1 pair of two-part steel ramps with a length of approx. 4.350 mm and a width of approx. 900 mm. • Hydraulically foldable ramps. • Ramps are individually hydraulically movable approx. 235 mm outwards and approx. 215 mm inwards. Additional equipment: • Front wall made of steel, pluggable, approx. 400 mm high • Connection strip for supply lines to the tractor unit, attached at the height of the outer frame profile. • Round NATO socket on the front connection strip. • Spiral cable for supplying the electro-hydraulic unit and/or the electric winch (35 mm², 3.5 m long) between the trailer and the tractor-trailer with plug (NATO-NATO). • 3 kW electro-hydraulic unit for controlling hydraulic processes, with the exception of hydraulic winches. • Parking position on the gooseneck for the warning signs when not in use. • 1 spare wheel with mounting adapter in front of the gooseneck's bulkhead. • Gooseneck outer support with mounting holes for screwable lashing rings. • The first hole approx. 200 mm from the front, then approx. every 400 mm. • 2 pairs of screw-in lashing rings included (LC 5.000 daN). • 1 pair of horizontal lashing rings in the rear area of the gooseneck (LC 10.000 daN). • On the gooseneck 1 pair of pluggable ALU side panels, approx. 400 mm high, anodized • On the gooseneck there is a plug-in aluminum back panel, approx. 400 mm high, anodized. • Approximately 40 mm thick hardwood covering above the gooseneck, Checker plate covering above the kingpin • 3.5" kingpin • Guide plate from the gooseneck for the saddle plate, approx. 500 mm wide. • 4 wheel chocks with holder in front of the front wall. • Mechanical seat posts with 2-speed gears and crank. • JOST Module B - static test load = 50.000 kg • Continuous 8/10 checker plate covering on the loading area. • Locking of the loading area with conically welded locking profiles every 250 mm. • Including pre-tensioning plate. • 1 pair of lashing rings on the front crossbar (LC 10.000 daN). • 8 pairs of recessed lashing rings in the outer frame of the loading area, foldable outwards (LC 10.000 daN). • Widenings (galvanized) can be extended by approx. 230 mm on each side • 1 pair of permanently installed wheel wells, open until they can be pulled out, approx. 700 x 410 mm